Wood decking
installation

decking installation video :

Download Flash Player to see video.

step-by-step installation video :

• 1. Position the first deck board and leave a 6mm gap from any permanent structure et fixez-la avec les vis spéciales composites Fiberdeck®
• 2. Pre-drill the first deck board with a 3mm drill. Use Cobra® screws along the outside edge. The screw placement should be at 25mm from the edge and 35mm from the end to prevent cracking of the board. Do not over-tighten the screws.
• 3. Insert COBRA® fastener into the groove channel of the board at every support joist. Install the screw (provided with the fasteners) and do not over-tighten yet
• 
• 4. Position the next board against the fastener. Slightly lift the outer edge of the board to ease the assembly of the board onto the fastener
• 
• 5. Tighten the COBRA® screws down. A special bit is provided. Continue the same procedure till the deck is finished. Adjust the final board and fix it with Cobra® screws.
• 
•